KONNWEI KW208 Car Battery Tester 12V 100 To 2000Cca Cranking Charging Circut Tester Battery Analyzer 12 Volts Battery Tools

KONNWEI KW208 12V car battery tester is able to effectively analyze and read important car data such as voltage internal resistance cold cranking amp and AH capacity battery health and charge status. It provides accurate results calculates the cold cranking capability of the battery and the aging extent allowing for a quicker more precise car repairing.

❐ The Benefits Of Choosing KONNWEI KW208 Car Battery Tester :

● Support multi-function: KW208 includes three testing methods: battery testing charging testing and Cranking testing. The function is to check the health of the battery and then provide you with a solutiongood recharge or replace

● Support a variety of batteries: batteries for cars trucks boats motorcycles Vans buses

● Support multiple standards: CCA BCI CA MCA JIS DIN IEC EN SAE GB

● Easy to carry: The KW208 as big as a slap can be carried with you to monitor your battery status at any time

● Review last time data: KW208 can view the data of the last battery check. You can compare the data of this time with the data of the last time to understand the recent battery usage

❐ KONNWEI KW208 Battery Tester Key Functions And Features :

● System voltage: 12 Volts
● Test Result: Good Recharge or Replace
● Capacity - Cold Cranking Amps (CCA) DIN EN and IEC information relative to battery rating
● Internal resistance value (mΩ)
● Life in percentage (%)
● Cranking system
● Charging system
● Voltage test in waveform
● Record and re-play battery data Life-time free update service
● Battery test cranking test charging test and other additional functions

Battery Testing

SOC (state of charge): refers to the state of charge of the battery which mainly describes how much power is left in the battery;If the battery runs out it will display 0%

SOH (state of health): refers to the state of health of the battery mainly describing the degree of battery aging

Cranking Test

The cranking test is used to test and analyze the actual required cranking current and cranking voltage to check the starting motor works properly or not. The test result displays cranking time voltage and status. If the stating malfunction may cause an increased starting loaded torque; or rotor friction of the starting motor generates increasing friction of the starting motor itself

Charging Test

Charging test is used to check and analyze the charging system (generator rectifier rectifier diode etc.) status displays load voltage unloaded voltage ripple status charging system status thus to find out whether the output voltage of the generator is normal the rectifier diode works properly or not which avoids damaging the battery and shortening its life greatly due to overcharging or incomplete charging

❐ KONNWEI KW208 Support Measure Standards :

● CCA:100-2000
● BCI:100-2000
● CA:100-2000
● MCA:100-2000
● JIS:26A17-24SH52
● DIN:100-1400
● IEC:100-1400
● EN:100-2000
● SAE:100-2000